HOPPE HLS 9000 multipoint locks
Lock case, or a whole new lock? Start with the smallest fix that works.
HOPPE sells this lock part by part. So a worn handle mechanism is one part to swap, and a new door is the last resort.
How the lock is put together
A multipoint lock looks like one long piece in the door's edge. It is several parts joined together:
- The lock case (also called the gearbox): the box behind the handle. It holds the latch, the deadbolt and the hub the handle turns.
- The faceplate strip: the long stainless steel strip you see in the door's edge.
- The extensions: the sections above and below the case that carry the upper and lower locking points.
- The handles, the key cylinder and the strikes in the frame. Each is its own part.
Locksmiths who repair these locks report that the lock case is the part that wears out, and that the upper half rarely breaks. That is why most repairs are smaller than they first look.
Three sizes of repair
1. The lock case only
When: the handle droops or won't spring back, or a gear inside the case has broken, and the strip and locking points are undamaged.
You keep: the faceplate, the upper and lower extensions, the handles, the key cylinder and the strikes.
You choose it by: two measurements, backset and deadbolt throw. Six sizes, in stock.
2. A gearbox with its lower extension
When: the faceplate strip or the lower locking point is damaged too.
You keep: the top extension, the handles, the key cylinder and the strikes.
You choose it by: more measurements, because the faceplate width and the type and position of the lowest locking point all have to match. Many versions are ordered in, and each product page shows its ship time.
3. The whole lock
When: the top section is damaged as well, the faceplate is bent where the sections join, or nothing matches the old gearbox.
You keep: the door, and usually the handles and key cylinder.
Which one is yours?
Test the lock with the door open. Press in the small spring plunger beside the latch, lift the handle and turn the thumbturn. Turn the thumbturn back and push the handle down before you close the door again.
| What you see with the door open | What to buy |
|---|---|
| Everything works. It fails only with the door shut | Nothing yet. The door is out of line: adjust the strike plates or hinges |
| The handle droops, clicks or won't spring back | The lock case |
| The faceplate strip or the lower locking point is bent or broken | A gearbox with its lower extension |
| The top locking point is bent, or the top doesn't move with the handle | Check the screw that joins the sections first, then a top extension |
| The faceplate is bent across the joint, or no gearbox matches | The whole lock |
| The key is stiff, lost or broken | The key cylinder only |
One caution before any of them
If the lock works with the door open and binds with it shut, fix the door first. A door that is out of line presses on the bolts every time you lock it, and that is the kind of load that wears a lock case out. A new case fitted to the same door would get the same treatment.
If the door is new, ask the door maker before you buy anything: the lock may be under warranty.
If the lock case is your repair
Two things are left to check, and both take a few minutes at the door:
- Confirm the lock is a manual HOPPE HLS 9000, with the stamp on the door's edge.
- Measure the backset and the deadbolt throw to pick your size.
Then see how the case is swapped. Allow time for comparison, reassembly and testing; the time needed depends on your experience and the condition of the door.
The part
HOPPE HLS 9000 replacement lock case
- Genuine HOPPE part, in six sizes
- Choose your size for price and availability
- Free US shipping and 90-day free returns