Shootbolt home

hoppemultipointlockreplacement.comHOPPE repair help by Shootbolt

Multipoint door won't lock

Why won't my multipoint lock lock? Usually the door, not the lock.

Most of the time the lock works and the door has sagged, so the locking points hit their strike plates. Lift the handle all the way, then try the lock with the door open: smooth open and stuck shut means adjust the door, not buy a part.

Why won't my door lock unless I lift the handle?

Because that is how a manual multipoint lock is meant to work. Most US multipoint doors lock in two moves, with the door fully closed:

  1. Lift the handle all the way up

    This throws every locking point at once, above and below the handle.

  2. Then turn the key or thumbturn

    Lifting alone doesn't lock the door. On most locks the key won't turn until the handle is fully up.

One US door maker says about a quarter of its "won't lock" calls are a handle that wasn't lifted all the way.

A few locks are automatic: the points throw by themselves as the door closes.

Stop forcing it

Forcing a key or handle against a bolt that is hitting metal is how keys snap and gears strip.

The handle won't lift? Test it with the door open

Beside the latch is a small spring plunger. It stops the points throwing while the door is open. If you don't hold it in, the handle won't lift with the door open, and a good lock looks broken.

  1. Open the door and hold the plunger in with one finger.

  2. Lift the handle, then turn the thumbturn. Watch every point come out.

  3. Turn the thumbturn back and push the handle down before you close the door. Closing it with the points out can damage the frame.

Adjust the door

It lifts easily open, but is hard or stops partway when shut, or lifts only while you push on the door.

The lock works. The door is out of line, or weatherstrip is pushing it away from the lock.

Tighten the hinge screws first, then move the strike that binds. How to adjust the hinges and strikes.

Check the plunger

It lifts open, but is blocked completely when shut.

The frame isn't pressing the plunger in as the door closes. A sagging door may no longer reach it.

Fix the sag first. A plunger turned the wrong way round blocks locking too: on HOPPE locks it pulls out and turns 180°.

Look at the lock

It is stiff, gritty or stops partway even with the door open and the plunger held.

The handle, the spindle or the lock case, not the door.

See stiff even with the door open below.

Stiff even with the door open

  • The handle moves but nothing happens: the square spindle has slipped, or its set screw is loose. On HOPPE levers that screw takes a 3 mm hex key.
  • Dry or gritty points: clean and lubricate them.
  • The bottom point moves and the top doesn't: a section has come apart from the case. Check the screw that joins them first.
  • Still crunchy, or it travels only partway: the lock case behind the handle is worn. On a manual HOPPE HLS 9000 it is a separate part, and the rest of the lock stays. See the lock case, and check your lock first.

Replacing the case? Fix the alignment too. A door out of line presses on the bolts every time you lock it, and that wears a case out.

The key won't turn to lock

  • Lift the handle fully first. On a HOPPE HLS 9000 the cylinder turns only 90 degrees, so a quarter turn can be its full travel. If the deadbolt throws, the lock works.
  • Try the spare key, and puff dry graphite into the keyhole. Skip oil.
  • With the door open: easy means the door is out of line. Stiff from the key side only points to the key cylinder, which comes out on its own. Stiff from the key and the thumbturn points to the lock case.

How to get French doors to lock

Lock the second door first. On a pair, the door you don't normally open (the inactive door) has to be bolted at the top and bottom before the main door locks into it. Some HOPPE systems won't let the main door lock until it is.

  1. Close the second door and throw its top and bottom bolts fully. On a handle-worked second door, lift its handle, then turn its inside thumbturn.

  2. Push on the second door. It shouldn't move. If it does, a bolt isn't in its hole.

  3. Close the main door, lift its handle all the way, then turn the key or thumbturn.

Still won't lock? Dirt in the sill hole or a sagging door can stop a bolt short. On a handle-worked second door, a HOPPE specialist reports a common fault: the top bolt's link to the gear is adjustable, and when it is off, the bolts go in but the door won't lock.

The lock case on this site is for the main door. The second door's gear has no latch or deadbolt and is a different part.

Questions

Why won't my multipoint lock lock?

Usually the door has sagged, so the points hit their strikes. Lift the handle fully, then test it with the door open. Smooth open and stuck shut means adjust the door.

Why won't my door lock unless I lift the handle?

That is how a manual multipoint lock works. Lifting throws the points; the key locks them.

Why won't my door handle lift up to lock?

If it lifts with the door open and the plunger held, the door is out of line. If it is stiff even open, look at the spindle, the points and the lock case.

How do I get French doors to lock?

Bolt the second door at the top and bottom first, then close the main door, lift its handle and turn the key.

Will a new lock case fix a door that won't lock?

Only if the lock is stiff or fails with the door open. If it works open and fails shut, a new case won't help: the door needs adjusting.

My outside door won't lock tonight. What do I do?

Throw the deadbolt if it still works. Otherwise brace the door from inside with a door security bar or a wedge, and keep another exit clear. A local locksmith can usually come the same day. If anyone is trapped or in danger, call 911.

Not sure which part you need? Use the instant part identifier, or send us a photo of the door's edge and tell us what the lock does. We reply by email within 1 business day.

Door locked shut instead? See a door stuck locked.

HOPPE HLS 9000 lock case with latch and deadbolt

The part

HOPPE HLS 9000 replacement lock case

  • Genuine HOPPE part, in six sizes
  • Choose your size for price and availability
  • Free US shipping and 90-day free returns
Choose my size You pay on shootbolt.com, our store.
HOPPE HLS 9000 gearboxFree US shipping · 90-day returnsView sizes
Choose size